Silver Bullet mk2 Meter Problems

If you are having trouble getting signal on your Silver Bullet mk2 meter, or experiencing any odd behavior please try the following:

1. Remove the top of your unit.
2. On the back corner of the meter PCB there is a small black button. This will cycle through the 3 meter modes
   1. SB mk2 "Knight Rider" startup mode
   2. SB mk1 "Standard" startup mode
   3. Calibration strobe mode
3. Try cycling through each mode to get to the desired mode (either a or b in most cases)

If that doesn't rectify your issue please try the following:

1. Turn the power to the SB Mk2 off.
2. Remove the ribbon cable connecting the meter PCB to the main PCB.
3. Reconnect the cable firmly to ensure the connection is solid.

If neither of these solutions fix your problem please reach out to customer support  for further guidance